How-To: Duck Tape® Heart Rose Ring

1

For the petals, cut a 1 in. long by 1 in. wide square of Duck Tape®. Lay this sticky side up on your crafting board.

2

Fold the top right corner over so there is one eighth of an inch of sticky part showing around both edges.

3

Fold the left top corner down so that there is one eighth of an inch of sticky side showing on the bottom.

4

Repeat steps 2-3 until you have 70 petals. Set these aside.

5

Cut a 2 in. long piece of floral wire and bend it in half around your ring base and twist in place. The twisted wire should be .75 in. long.

6

Wrap one of your petals around the top so the top of the wire is not visible.

7

Continue to add petals working the same direction. Stop at the 26th petal (blue petals show the 26th and 27th petal) skip 2-3 petals to give the heart its indent.

8

Skip 2-3 petals and begin building another layer of petals. (purple petals show how to place the petals to make the top of the heart)

9

Continue to build layers of petals until you’ve reached a desired size. Use a small piece of Duck Tape® on the bottom of the rose over the wire and ring.

10

Place the ring on your finger or give it as a gift!